한국 1588-8983 | 새로운 웹사이트에 오신 것을 환영합니다. 문제나 버그를 발견하셨나요? 여기에 보고해주세요
HTC
유리섬유 히터 코드 900 °F 최대 및 120-240 볼트
재고가 있는 모델
- 최대 노출 온도 482°C (900°F)
- 최소 감김 직경 3.2 mm (1/8')
- 니트 및 꼬임 유리섬유 구조
- 전력 밀도: 0.003 W/mm2 (1.8 W/in2)
- 테스트
제품 개요
- 추가 기능 1 전기 전도성 표면에 적합함
- 외함 등급 IP5X
- 노출 온도, 최대 482 °C
- 히터 직경 0.125 in
- 히터 폭 0 in
- 단열 이중 꼬인 유리섬유
- 리드 와이어 출구 방향 반대편
- 리드선 출구 방향 사양 참고 Separable molded plug on each end
- 제품 구조 옵션 해당 없음
- 전력 밀도, 최대 1.8 W/in²
- 시리즈 ID HTC
- 온도조절기 유형 내장되지 않음
- 와이어 길이 24 in
Supported Applications
The Omega HTC Series Fiberglass Heater Cords are designed for use on small-diameter tubes, vessels, or wherever space is limited. These heating cords can be wrapped around tubing as small as 3.2 mm (1/8") diameter. The double-braided fiberglass outer sheath ensures durability for laboratory, production, or maintenance applications.
Operating Conditions & Performance
The HTC Series features a maximum exposure temperature of 482°C (900°F). Constructed with high-quality resistance wire and braided insulation, the series is engineered to provide long life and high performance. The heating element section has a width of 230 mm (9") as shown in diagrams.
Operational safety requires that the heater be connected to an external control device; it must not be operated without some form of temperature control. Users should ensure the heater is protected by a properly sized circuit breaker or fuse, and use of a ground fault circuit interrupter is highly recommended. The series carries a 1 YEAR WARRANTY.
Configuration Options
The HTC Series offers configurable lengths to accommodate different heating requirements. All models utilize a separable molded plug for electrical connection.
- HTC-030: Heating cord 0.9 m (3'), 64 W, 120V
- HTC-060: Heating cord 1.8 m (6'), 125 W, 120V
- HTC-120: Heating cord 3.6 m (12'), 260 W, 120V
The series supports a portable thermocouple temperature controller option: CN-TOT-175JF-120V.
Key Product Differences
Variants within the HTC Series differ primarily by length and wattage, while maintaining consistent voltage (120 Vac) and sheath material. The model number guide follows the format HTC-<Length Code>, corresponding to lengths of 3 feet, 6 feet, or 12 feet.
Installation requires fastening the heater to a device using approved methods only, such as aluminum tape, fiberglass tape, or mechanical clamping devices that will not cause damage. The heating tape must not be kinked, twisted, or allowed to hang free from the surface, and overlapping of the tape on itself is prohibited.