DMD1080

ALARM MODULE - DC INPUT TO SINGLE ALARM

Click and hold to zoom

Supply Voltage

60 to 265 Vac 9 to 30 Vdc

$428.80 / each

Item# DMD1080

Added to Your Shopping Cart

In Stock

Lead Time (If not in stock): 7 weeks

Brand
Enclosure Ratings	IP40
GrossWeightValue	0.53
Height	117 mm
Impedance Input	Voltage: 250 kΩ minimum,Current: 50 Ω typical,Voltage Burden: 1 Vdc at 20 mA current input
Input Range Note	24 field selectable ranges via switch settings_x000D_ Voltage: 0-50 mV to 0-10 Vdc_x000D_ Bipolar Voltage: ±5 Vdc or ±10 Vdc_x000D_ Current: 0-1 mADC to 0-20 mADC, 4-20 mADC
Isolation	1200V Isolation: power to input 600 Vac or 600 Vdc common mode protection
Length	122 mm
Number of Outputs	2
Operating Temperature, Max	60 °C
Operating Temperature, Min	-10 °C
Output Detail	8 Amps @ 240 Vac resistive load 5 Amps @ 240 Vac inductive load 8 Amps @ 30 Vdc resistive load 3.5 Amps @ 30 Vdc inductive external contact protection such as a RC snubber is recommended for inductive loads
Power Consumption	2 W
Reset	Toggles relay to opposite state when pressed; resets latching relay if latching relay mode is selected
Response Time	70 ms
Series ID	DMD-Srs-Alarm-Module
Supply Power Note	60 to 265 Vac, 50/60 Hz or 85 to 300 Vdc, 2W maximum; Input Loop Power Supply: 15 Vdc ±10%, 25 mADC maximum ripple, less then 10 mV rms may be wired for sinking or sourcing mA input
Supply Voltage	60 to 265 Vac
Temperature Stability	better than 1% of span over operating temperature range; better than 0.02% of span per °C
Width	22.5 mm
Wire Gauge	14 AWG
Country of Origin	United States
See All Specs Show Less

PDFs & Manuals

Show Ratings & Reviews