1-800-663-4209 | Welcome to our new website, found an issue or bug? Please report it here
DRSP-I-Srs-DC-Splitter
DIN Rail DC Current Signal Splitters w/ Dual Output
- One 4 to 20 mA Input to Two 4 to 20 mA Outputs with Full Isolation
- Zero and Span Adjustments for Each Output
- Full 1200 V Input/Output/ Power Isolation
- Input/Output Loop Status LEDs
DRSP-I-Srs-DC-Splitter
From
$
768.86
Product Overview
- CMRR 120 dB minimum
- Current Measurement Range 4 to 20 mA
- Electrical Connection Screw Terminal
- Electrical Output 4 to 20 mA
- Enclosure Ratings IP40
- Height 117 mm
- Impedance Input 50 Ω typical
- Input Range Note Input Loop Power Supply:15 Vdc ±10%, regulated, 25 mA;May be selectively wired for sinking or sourcing mA input;Loop Status LEDs: Variable brightness LEDs indicate I/O loop level and status; One for input, one for each output.
- Isolation Isolation (Full 4-Way Isolation):input 1, output 1, output 2, power;1200 VRMS minimum
- LED Indicators Loop Status LEDs: Variable brightness LEDs indicate I/O loop level and status; One for input, one for each output
- Length 122 mm
- Linearity Output Linearity: ±0.1% of span
- Mounting DIN Rail 35 mm Standard
- Number of Inputs 1
- Operating Temperature, Max 60 °C
- Operating Temperature, Min -10 °C
- Output Detail (Output 1 and Output 2): 4 to 20 mA;20V compliance, 1000 Ω at 20 mA Output Zero and Span: Multi-turn zero and span potentiometers for each output channel to compensate for load and lead variations; ±15% of span adjustment range typical Output Loop Power Supplies: One for each output channel; 20 Vdc nominal, regulated, 25 mA may be selectively wired for sinking or sourcing mA output. Output Functional Test: Front buttons set each output to test level when pressed; Each test level potentiometer adjustable 0 to 100% of span
- Output Ripple Output Ripple and Noise: <10 mVRMS
- Output Signal Current
- Output Value Splitter
- Response Time 70 ms typical
- Stability ±0.04% of span per °C
- Width 45 mm
- Wire Gauge 14 AWG
The DRSP-I Series DC current signal splitters accept one 4 to 20 mA current input and provide two optically isolated 4 to 20 mA current outputs that are linearly related to the 4 to 20 mA current input. This provides an economical solution when one signal must be sent to two different devices. Typical applications include isolation, output splitting, output device separation and redundancy (i.e. to prevent failure of the entire loop if one device fails), or a combination of these. The input signal is filtered, amplified, split, and then passed through an opto-coupler to the output stages. Full 4-way isolation (input, output 1, output 2, power) make this module useful for ground loop elimination, common mode signal rejection,and noise pickup reduction.
PDFs & Manuals
Show Ratings & Reviews
Rated 5 out of
5
by
Windsor Township from
Municipal Electrician
Always encounter a helpful staff and a fair amount of stock
Date published: 2021-02-09