France 0805 541 038 | Intl +31 01 57 32 48 17 | Bienvenue sur notre nouveau site web! Vous avez rencontré un problème ou un bug ? Veuillez le signaler ici.
SSHB-Series
Couverture chauffante flexible en caoutchouc de silicone 450 °F max jusqu'à 48 in
Silicone Rubber Flexible Heater Blanket 450 °F Max up to 48 in- Moisture and Chemical Resistant
- Constant Low Watt Density of 2½W/in2
- Maximum Exposure Temperature of 450°F
- Five Standard Sizes
SSHB-Series
À partir de
£
89.23
Aper çu du produit
- Diameter 0 in
- Dielectric Strength 2000 V
- Insulation Silicone Rubber
- Insulation Note 4' long, 16 AWG, silicone rubber insulated
- Lead Length 4 in
- Operating Temperature, Min -56 °C
- Power Density, Max 2.5 W/in²
- Series ID SSHB-Series
- Wire Gauge 16 AWG
Supported Applications
The Omega SSHB Series consists of rugged, low-cost flexible heating blankets constructed from OMEGALUX® silicone rubber. Designed for efficient process temperature control and freeze protection, these heaters are intended for use on both flat and curved surfaces. Documented applications include:
- Storage Tanks
- Conveyors
- Water and Feed Troughs
- Dust Collectors
- Tank Trucks
- Process Vats and Dip Tanks
- Melt Pots
Operating Conditions & Performance
The SSHB Series features a constant low watt density of 2.5 W/in² with a maximum exposure temperature of 232°C (450°F). The blankets are moisture and chemical resistant, offering dielectric strength rated at 2000V. Standard configurations include a 4' long, 16 AWG silicone rubber insulated lead wire.
Power supply options support 120, 240, or 480 Vac (contact Omega for 480V models). Wattage ratings available in the series are 180 W, 360 W, 720 W, and 1440 W. The heaters operate at a specific voltage ±10%.
Configuration Options
The SSHB Series is configurable across five standard sizes: 6 x 12", 6 x 24", 12 x 12", 12 x 24", and 24 x 24". Models are available with or without optional pressure-sensitive adhesive (PSA), indicated by the "-P" suffix in the model number.
Installation accessories include:
- Junction boxes
- Wire ties and mounting hardware
- SRL-CB conduit bracket for additional cost
- RTV adhesive sealant (ordered separately)
Key Product Differences
The SSHHB Series model number follows the format: SSHB-<dimensions>-<watts>-<volts>-P. For example, a 6 x 12" heater with 180 W at 120 VAC without adhesive is ordered as SSHB-612-180-120; the same unit with pressure-sensitive adhesive is SSHB-612-180-120-P. The series carries CE approval.
Installation notes specify that power lead wires are non-polarized, allowing either wire to connect to neutral or hot, while a third green (or green-striped) ground wire must be connected if applicable. Heaters should not be operated without an appropriate heat sink or temperature control device.
PDF & Manuels
