United Kingdom 0800 488 488 | Intl +44 (0) 161 777 6611 | Welcome to our new website, found an issue or bug? Please report it here
KE-HEATER
260 °C Max Constant Wattage Heating Cable 120-480 Vac
- Continuous Exposure Rating up to 500°F
- Low Watt Density
- Parallel Resistance Heater
- Cut-to-Length at the Job Site
Product Overview
- Cable Length 1 in
- Cable Length, Max 202 in
- Cable Material Nickel, Copper
- Dielectric Strength 2500 V
- Heater Wire Material Nichrome
- Insulation 20 Mil PFA
- Module Length 4 ft
- Operating Temperature, Max 148 °C
- Operating Temperature Note Exposure Temperature: 0 to 260 °C; Short Term Exposure Temperature: 287 °C
- Purchase Note Use quantity to indicate length of cable to purchase (increments of 1 foot), min purchase of 25 ft
- Series ID KE-HEATER
- Wire Gauge 12 AWG
- Wire Thickness 0.33 in
- Wire Width 0.225 in
The KE Cable heating element is tension wrapped and covered with two layers of nonflammable Polyimide Film applied in reverse directions, then heat fused for moisture protection. A stainless steel and tinned copper sheath is then added for additional protection and electrical ground return path. The sheath is enclosed in a minimum 20 mil PFA abrasion and chemical resistant extruded jacket.
OMEGALUX® KE Cable is a low Watt density electrical resistance heater. It is designed for freeze protection, viscosity and high temperature process control in Class 1, Groups B, C, and D, Division 2 Classified Areas as well as in corrosive environments. KE is used in asphalt plants, oil refineries, mines, chemical and petrochemical processing areas, other locations where corrosive atmospheres can occur. KE is equally suitable for applications in severe arctic cold.
CAUTION AND WARNING!
Fire and electrical shock may result if products are used improperly or installed or used by non-qualified personnel. See inside back cover for additional warnings.
OMEGALUX® KE Cable is a low Watt density electrical resistance heater. It is designed for freeze protection, viscosity and high temperature process control in Class 1, Groups B, C, and D, Division 2 Classified Areas as well as in corrosive environments. KE is used in asphalt plants, oil refineries, mines, chemical and petrochemical processing areas, other locations where corrosive atmospheres can occur. KE is equally suitable for applications in severe arctic cold.
CAUTION AND WARNING!
Fire and electrical shock may result if products are used improperly or installed or used by non-qualified personnel. See inside back cover for additional warnings.
PDFs & Manuals