1-800-663-4209 | Welcome to our new website, found an issue or bug? Please report it here
DMD1080
ALARM MODULE - DC INPUT TO SINGLE ALARM
Choose a Variant
Supply Voltage
Added to Your Shopping Cart
Configuration complete.
Please add to cart to keep it or exit the configuration
Please add to cart to keep it or exit the configuration
Failed to Save Configurations, Click on Configure Button Start Again
Product Specs
<< See all Product Models| Brand |
 |
| Enclosure Ratings | IP40 |
| GrossWeightValue | 0.53 |
| Height | 117 mm |
| Impedance Input | Voltage: 250 kΩ minimum,Current: 50 Ω typical,Voltage Burden: 1 Vdc at 20 mA current input |
| Input Range Note | 24 field selectable ranges via switch settings_x000D_ Voltage: 0-50 mV to 0-10 Vdc_x000D_ Bipolar Voltage: ±5 Vdc or ±10 Vdc_x000D_ Current: 0-1 mADC to 0-20 mADC, 4-20 mADC |
| Isolation | 1200V Isolation: power to input 600 Vac or 600 Vdc common mode protection |
| Length | 122 mm |
| Number of Outputs | 2 |
| Operating Temperature, Max | 60 °C |
| Operating Temperature, Min | -10 °C |
| Output Detail | 8 Amps @ 240 Vac resistive load 5 Amps @ 240 Vac inductive load 8 Amps @ 30 Vdc resistive load 3.5 Amps @ 30 Vdc inductive external contact protection such as a RC snubber is recommended for inductive loads |
| Power Consumption | 2 W |
| Reset | Toggles relay to opposite state when pressed; resets latching relay if latching relay mode is selected |
| Response Time | 70 ms |
| Series ID | DMD-Srs-Alarm-Module |
| Supply Power Note | 60 to 265 Vac, 50/60 Hz or 85 to 300 Vdc, 2W maximum; Input Loop Power Supply: 15 Vdc ±10%, 25 mADC maximum ripple, less then 10 mV rms may be wired for sinking or sourcing mA input |
| Supply Voltage | 60 to 265 Vac |
| Temperature Stability | better than 1% of span over operating temperature range; better than 0.02% of span per °C |
| Width | 22.5 mm |
| Wire Gauge | 14 AWG |
| Country of Origin | United States |
| See All Specs | |
PDFs & Manuals
Show Ratings & Reviews