Netherlands 07077 03815 | Intl +31 (0) 7077 03815 | Welcome to our new site - found a bug? Please report it here
SA1-RTD-B-series
Self-Adhesive Polyimide Fast Response RTD Surface Sensors, Class B Accuracy
Models In Stock
- 100 Ohm Thin Film DIN Platinum Class “B” (± 0.12 Ohms, ± 0.30°C at 0°C) Accuracy Standard
- Silicone Adhesive rated to 260°C (500°F)
- Temperature Range -73C to 260°C Continuous, 290°C (554°F) Short Term Operation When Installed with OMEGABOND Air Set Cements
- Stocked in 1m (40”) Lengths
SA1-RTD-B-series
From
€
204,22
Models In Stock
Can't find the right model?
Use our custom configurator to fine tune your product
Product Overview
- Accuracy Class B
- Accuracy Detail 100 Ω Thin Film DIN Platinum Class “B” (± 0.12% at 0°C) Accuracy Standard
- Insulation PFA
- Mounting Class DIN Platinum
- Nominal Resistance 100 Ω
- Pack Size 3
- Process Temperature, Max 260 °C
- Process Temperature, Min -73 °C
- Response Time In Water Immersion : <0.9 sec ; On a Hot Plate: <2 sec
- Temperature Coefficient 0.00385 Ω/Ω/°C
- Temperature Coefficient Note α = 0.00385 Ω/Ω/°C
- Temperature Sensor Type RTD
- Wire Gauge 26 AWG
The SA1-RTD is a surface temperature sensor that can be applied to most clean, dry surfaces. Just peel off the release sheet on the bottom of the sensor and the silicone adhesive bonds the sensor to the surface, no cements or epoxies to mix, apply and cure.
The thin design of the SA1-RTD minimizes the effects of having the sensor attached to the surface of interest. Containing a thin film platinum sensing element, the SA1-RTD resistance is not affected by mounting to curved surfaces. With a fast thermal response time, the SA1-RTD will quickly respond to changes in temperature for fast, reliable measurements.
PDFs & Manuals
