Netherlands 07077 03815 | Intl +31 (0) 7077 03815 | Welcome to our new site - found a bug? Please report it here
FMG70B-Series
Pulse or Current Output Low Flow Electromagnetic Flow Meter
Models In Stock
- No Moving Parts
- No Flow Obstructions
- Maintenance-Free
- Fast Response Time (< 500 ms)
FMG70B-Series
From
€
850,00
Models In Stock
Product Overview
- Accuracy ± 1.5 %
- Accuracy Detail ± 1.5% of reading ± 0.3% range
- Conductivity 50 µS/cm
- Electrical Connection M12 4 pin Female
- Enclosure Ratings IP65, NEMA Type 4X
- Flow Indication LED Green
- Flow Indication Note flow proportional blinking
- Load Resistance 250 Ω
- Materials PEEK, Aluminum
- Materials, Wetted EPDM, Stainless Steel
- Current, Max 26_ma_approx
- Media Compatibility Acid Solutions, Conductive Liquids, Saltwater
- Number of Outputs 1
- Operating Pressure, Max 232 psi
- Operating Temperature, Max 70 °C
- Operating Temperature, Min 5 °C
- Output Detail Amplified Square Wave
- Output Pulse Rate Note Square wave signal NPN, internal pull-up resistor 2 kΩ pulse duty ratio 50:50
- Power Consumption 150 mA
- Process Temperature, Max 90 °C
- Process Temperature, Min 0 °C
- Repeatability ± 1%
- Response Time < 500 ms
- Short-Circuit Protected < 30 V
- Short-Circuit Protected Note Measures short-circuit proof (up to 30V) and polarity protection (up to -30V)
- Supply Power Note 24 Vdc ± 10%
- Supply Power Type DC
- Supply Voltage 24 Vdc
The FMG70B Series from OMEGA is a trio of extremely compact, low cost, inductive magnetic flow sensors. This product line allows a unique and highly reliable measuring technique to be introduced into areas of process control previously considered not possible.
Changes of temperature, density, viscosity, concentration or electrical conductivity (minimum conductivity of 50 µs/cm) of the fluid do not affect the output signal.
FMG70B series can be used in areas where flow sensors with moving parts e. g. paddle wheel sensors, cannot be applied due to contamination/particulate in the media. The sensor is intended for continuously measuring of flow rates or for dosing/batching of electrically conductive liquids (minimum conductivity 50 S/cm). The output signal frequency (or current) is proportional to the flow. Two options are available for output signals, frequency or analog (-A models).
Changes of temperature, density, viscosity, concentration or electrical conductivity (minimum conductivity of 50 µs/cm) of the fluid do not affect the output signal.
FMG70B series can be used in areas where flow sensors with moving parts e. g. paddle wheel sensors, cannot be applied due to contamination/particulate in the media. The sensor is intended for continuously measuring of flow rates or for dosing/batching of electrically conductive liquids (minimum conductivity 50 S/cm). The output signal frequency (or current) is proportional to the flow. Two options are available for output signals, frequency or analog (-A models).
PDFs & Manuals
Accessories
accessories
DC Cable Assemblies for Probes, Sensors and Transmitters
€ 32,44 / each
0 In Stock