Netherlands 07077 03815 | Intl +31 (0) 7077 03815 | Welcome to our new site - found a bug? Please report it here
FLSC-AMP-Low-Lvl-Amp
Low Speed Amplifier | Drives any Omega Ratemeter
Models In Stock
- Ultra Low Speed to 15 kHz Operation
- 20 mV to 50 V Sensitivity
- 100 mA Current Sinking Output
- 11 to 26 Vdc Power Supply Range
FLSC-AMP-Low-Lvl-Amp
From
€
124,88
Models In Stock
Product Overview
- Height 35.6 mm
- Impedance Input 1500 Ω
- Input Range 0.020 to 50 V
- Input Type Voltage
- Length 76.2 mm
- Operating Temperature, Max 60 °C
- Operating Temperature, Min 0 °C
- Output Detail Open Collector with internal 2700 ohms pull-up resistor to supply voltage. 100 mA Maximum sink to 1 v or less
- Supply Power 11 to 26 Vdc; 30mA Max
- Supply Power Type DC
- Width 55.9 mm
The OmegaTM FLSC-AMP amplifies the low level signals from the magnetic pickup of gear teeth or flow transmitters by a factor of more than a hundred times to drive any Omega rate meter, counter or controller. It is mounted in a rugged 2 x 3" metal housing with screw terminals for easy installation.
NOTE:
The low voltage line from the magnetic pickup to the FLSC-AMP should be less than 3 m (10') in length, shielded and isolated from relays, solenoids or other sources of electrical noise (let the output line make the long run). If the input is too sensitive, lower the 1.1K input impedance by adding a 220 to 1 KO resistor across TB1, pins 1 and 2, to increase noise immunity.
The low voltage line from the magnetic pickup to the FLSC-AMP should be less than 3 m (10') in length, shielded and isolated from relays, solenoids or other sources of electrical noise (let the output line make the long run). If the input is too sensitive, lower the 1.1K input impedance by adding a 220 to 1 KO resistor across TB1, pins 1 and 2, to increase noise immunity.
