Netherlands 07077 03815 | International +31 (0) 7077 03815 | Attention: Our sites will be down for maintenance after business hours April 10-12.
OM-USB-TEMP
Eight Channel Temperature/Voltage Input USB Data Acquisition Modules
Choose a Variant
Number of Channels, Input
Output Signal
Added to Your Shopping Basket
Configuration complete.
Please add to basket to keep it or exit the configuration
Please add to basket to keep it or exit the configuration
Failed to Save Configurations, Click on Configure Button Start Again
Product Specs
<< See all Product Models| Brand |
 |
| A/D Conversion | Four dual 24-bit sigma delta A/D converters |
| Accuracy | ± 0.25 °C |
| Analog I/O Note | Analog Input Note: A/D Converter;Four dual 24-bit sigma delta A/D converters;Input Isolation: 500 Vdc minimum between field wiring and USB interface;Number of Channels;OM-USB-TEMP-AI: 8 differential temperature inputs;Thermocouple Input: Software programmable for type J, K, T, E, R, S, B, N;Pt100 RTD Input: 2, 3 or 4-wire DIN 43760, a = 0.00385, SAMA, a = 0.003911, ITS-90/IEC751, a = 0.0038505;Thermistor Input: 2, 3 or 4-wire standard 2252 through 30,000 Ω;Semiconductor Sensor: TMP36 or equivalent;Maximum Input Voltage;Temperature inputs; ±25V (power on), ±40V (power off): voltage inputs; ±25V (power on), ±15V (power off);Throughput Rate: 2 samples/sec max for all active channels;Input Impedance: Temperature inputs; 5 GΩ(power on), 1 MΩ (power off): voltage inputs; 10 GΩ(power on), 2.49 KΩ(power off);Input Leakage Current;Thermocouples inputs; 105 nA maximum (with open thermocouple detection enabled), 30 nA maximum (with open thermocouple detection disabled): voltage inputs; ±1.5 nA typ, ±25 nA max; |
| CMRR | Thermocouple inputs, 100 dB min |
| Configuration Parameters | Pull-Up/Down Configuration, User-Configurable Input/Output |
| Data Interface | Ethernet, USB 1.1, USB 2.0 |
| Data Interface Note | Configuration Method: TracerDAQ Software;Supported Operating System: Microsoft Windows® VISTA/7/8/10 (32-bit and 64-bit) |
| Digital I/O Note | DIGITAL I/O Number of Digital I/O Channels: 8 Type: CMOS Configuration: Each DIO bit can be independently configured for input or output; power on reset is input mode Pull-Up/Pull-Down Configuration:All pins pulled up to 5V via 47 kΩresistors (default). Pull-down to ground (GND) also availableDigital I/O Transfer Rate (Software Paced):Digital Input: 50 port reads or single bit reads per second (typical) Digital Output: 100 port writes or single bit writes per second (typical) Input High Voltage: 2.0V min, 5.5V absolute max Input Low Voltage: 0.8V min, -0.5V absolute min Output High Voltage: 0.7V max (IOL = 2.5 mA) Output Low Voltage: 3.8V min (IOH = -2.5 mA);Transfer Rate: Digital: Input: 50 port reads or single bit reads per second (typical), Output: 100 port writes or single bit writes per second (typical) |
| Digital Input | Digital: Low = –0.5 to 0.8 Vdc |
| Digital Output | <100 mA typical |
| Electrical Connection | Screw Terminal |
| Frequency Input Range | 1 MHz |
| GrossWeightValue | 1.11 |
| Height | 36 mm |
| Impedance Input | Thermocouple inputs; 5 GΩ (power on), 1 MΩ (power off) |
| Input Configuration | Connected Software |
| Input Type | Thermocouple, RTD, Thermistor, Diode, Digital |
| Input Type Note | Thermocouple: J, K, T, E, R, S, B, N, RTD: pt100, 2, 3 or 4-wire DIN 43760, a = 0.00385, SAMA, a = 0.003911, ITS-90/IEC751, a = 0.0038505, Thermistor: 2, 3 or 4-wire standard 2252 through 30,000 Ω, Semiconductor Sensor: TMP36 or equivalent |
| Input Voltage Note | Absolute Maximum Input Voltage: Thermocouple Inputs; ±25V (Power On), ±40V (Power Off): Voltage Inputs; ±25V (Power On), ±15V (Power Off) |
| Isolation | Power Isolation: 500 Vdc minimum measurement system to PC, Input Isolation: 500 Vdc min between field wiring and USB interface |
| Leakage Current | 105 nA |
| Length | 127 mm |
| Number of Channels, Input | Temperature: 8 DIFF, Digital: 8 |
| Number of Channels, Output | Digital: 8 |
| Operating Temperature, Max | 50 °C |
| Operating Temperature, Min | 0 °C |
| Output Signal | Digital |
| Pull-down Resistor | 47 kΩ |
| Pull-up Resistor | 47 kΩ |
| Relative Humidity | 0 to 90% RH non-condensing |
| Sampling Rate | 2 Hz (2 updates/second) |
| Series ID | OM-USB-TEMP-Series |
| Storage Temperature, Max | 85 °C |
| Storage Temperature, Min | -40 °C |
| Supply Power Note | Power Supply Voltage (Supplied by USB Port): 4.75V min to 5.25V maximum, Power Supply Current (Supplied by USB Port): <100 mA typical (USB enumeration); 270 mA typical for continuous input with all inputs configured for disabled mode (500 mA for OM-USB-5201) User 5V Output Voltage Range (connected to self-powered hub): 4.75V min to 5.25V maximum User 5V Output Current (bus powered and connected to self-powered hub);10 mA maximum |
| Supply Voltage | 5 Vdc |
| USB Cable Length | 3 m |
| Warm Up Time | 30 min |
| Weight | 182 g |
| Width | 89 mm |
| Wire Gauge | 30 to 16 AWG |
| Country of Origin | Hungary |
| See All Specs | |
PDFs & Manuals
Software & Drivers
