Netherlands 07077 03815 | Intl +31 (0) 7077 03815 | Welcome to our new site - found a bug? Please report it here
AHPF-HEATER
316 SS Inline Duct Heater up to 800 °F and 1.2 kW Power-Liq
- 316 Stainless Steel Construction
- Air/Gas Flow up to 15 CFM
- Air/Gas Outlet Temperatures up to 800°F (430°C)
- Pressures up to 100 PSI*
AHPF-HEATER
From
€
560,74
Product Overview
- Air Flow, Max 15 CFM
- Mounting Inline
- Outer Diameter 1.25 in
- Outlet Air Temperature, Max 430 °C
- Port 1 Size 3/8 in
- Port 1 Type NPT Male
- Port 2 Size 1/2 in
- Port 2 Type NPT
- Power Tolerance +5, -10%
- Sheath Material 316 Stainless Steel
The AHPF series heaters are used to heat low flows of air, gas, water, or aqueous solutions. Applications include those where clean air is necessary, as in laboratories and environmental testing areas. The stream of air is heated by passing over an enclosed heated surface rather than directly over resistance elements. This method assures that no foreign matter will enter the stream of flow. The AHPF series is also used as a miniature circulation heater for small volume liquids as in photographic developer solution, chemicals, dyes, and inks. Calculate the flow rate, temperature rise, or power requirement as described on page J-17. For heating liquids, use the formulas on pages Z-10 or Z-41. The Thermocouple "T" fitting AHPF-NPT12 can be used with the sub-miniature thermocouple probes and with the SSLK series stainless steel compression fittings (see the OMEGA Complete Temperature Measurement Handbook and Encyclopedia®) and with stainless steel compression fittings (model SSLK-18-14) to monitor or control temperature at the outlet of the AHPF series heaters.
PDFs & Manuals
