Taiwan 0809 090 375 | Intl +65 6415 5353 | Welcome to our new site - found a bug? Please report it here
DRST-CM-Programmer
Snap In Front Panel Programmer with Modbus over RS-485
Models In Stock
- Programming Display for DRST-AC, DRST-DC, DRST-UN, DRST-UR
- Modbus Protocol Interface Over RS485
- Monitor Process Value From the Built-In Display
- High 2.5 kV Isolation to Host Unit
DRST-CM-Programmer
From
TWD
7,795
Models In Stock
Product Overview
- Approvals Note EMC:2014/30/EU, LVD:2014/35/EU, EAC:TR-CU 020/2011
- Data Interface RS485, Modbus RTU
- Electrical Connection RJ45
- EMC Immunity Note NAMUR NE21, A criterion, burst: No loss of communication
- Enclosure Ratings IP20
- Height 73.2 mm
- Installation Pollution degree 2 and measurement/overvoltage category II
- Isolation Isolation voltage, test/working :2.5 kVAC / 250 VAC reinforced isolation
- Length 26.5 mm
- Noise Calibration >60 dB
- Operating Temperature, Max 60 °C
- Operating Temperature, Min -20 °C
- Power Consumption max 0.15 W
- Relative Humidity <95% RH
- Response Time < 20 ms
- Response Time Note Response delay: 0…1000 ms Data rates, baud: 2400, 4800, 9600, 19200,38400, 57600, 115200 Automatic baudrate detection: Yes - can be configured ON or OFF Parity: Even, Odd, None Stop bit(s): 1 or 2 Digital addressing: 1...247 Response delay: 0...1000 ms
- Series ID DRST-CM-Programmer
- Storage Temperature, Max 85 °C
- Storage Temperature, Min -20 °C
- Update Rate > 50 Hz
- Weight 30 g
- Width 23.3 mm
Supported Applications
The Omega DRST-CM Programmer is a front panel programmer designed for use with DIN rail signal conditioners. It provides local configuration capabilities within data acquisition and signal conditioning systems.
Operating Conditions & Performance
No specific operating conditions, performance metrics, or environmental ratings are documented in the available source bundle for this series.
Voltage and Power Requirements
- Power specifications: Not specified in current documentation.
Configuration Options
The DRST-CM Programmer is offered as a single variant within the DIN rail signal conditioners family. The series supports Modbus communication over an RS-485 interface for configuration tasks.
Communication and Interface Options
- Protocol: Modbus
- Physical Layer: RS-485
- Mounting Style: Snap-in front panel design intended for DIN rail signal conditioner systems.
Key Product Differences
The available documentation identifies the DRST-CM as a single model within this series. No alternative housings, output types, or sensor element variations are documented in the current bundle.
