Taiwan 0809 090 375 | Intl +65 6415 5353 | Welcome to our new site - found a bug? Please report it here
HDR
Worm Gear Speed Reducers
- 8 Ratios Available from 5:1 to 60:1
- 7 Gear Box Sizes from 1.33 to 3.25'
- Universally Interchangeable Design for OEM Replacement
- Double Bearings Used on Both Shaft Ends
HDR
From
Product Overview
The HDR Series worm gear reducers are used in low to moderate horsepower applications to reduce speeds and increase torque. Worm gear reducers are available in direct or indirect drive, direct drive models are 56C or 145TC flange mount with either right, left or dual output shafts or a hollow bore output. The indirect drive models are shaft input-shaft output boxes for use with sprocket or pulley drive systems. They provide an effective low cost solution to speed reduction and increased torque, with higher tolerances for shock loading than helical gear reducers.
In order to select a gearbox speed reducer, you will need to determine the required torque and service factor for the application. Click on 'Specs' above for a table that will assist in determining the service factor. For service factors above 1.0, multiply the required torque by the service factor.
Use the Part Number Builder (below the ordering table) to find additional models
In order to select a gearbox speed reducer, you will need to determine the required torque and service factor for the application. Click on 'Specs' above for a table that will assist in determining the service factor. For service factors above 1.0, multiply the required torque by the service factor.
Use the Part Number Builder (below the ordering table) to find additional models