Besoin d'aide? Appelez-nous: 1-800-663-4209
LC901
Laveuses à charge pour mesurer la compression des boulons
Modèles en stock
- All Stainless Steel Construction
- Mounting Washers Included
- NIST Calibration Certificate
LC901
À partir de
C$
799.75
Modèles en stock
Aperçu du produit
- Accuracy ± 3.5 %
- Bridge Resistance 120 Ω
- Calibration Option 5 POINT NIST
- Electrical Output 2 mV/V
- Force Type Compression
- Load Cell Type Load Washer
- Materials Stainless Steel
- Operating Temperature, Max 93 °C
- Operating Temperature, Min -54 °C
- Overload, Max 150% FS
- Process Temperature, Max 71 °C
- Process Temperature, Min 16 °C
- Safe Overload 150% FS
- Series ID LC901
- Supply Power Note 10 Vdc, 15 Vdc maximum
- Supply Voltage 10 Vdc
- Thermal Span Effect ± 0.036% rdg/°C
- Thermal Zero Effect ± 0.018% FSO/°C
- Zero/Balance Error ± 4%
Le capteur de force de boulon de la série LC900 d'OMEGA est un capteur de force à compression conçu pour mesurer la force de serrage d'un boulon. Avec une excellente stabilité à long terme et une construction entièrement en acier inoxydable, la série LC900 offre une grande fiabilité dans les environnements industriels difficiles. Cet appareil est conçu pour fonctionner en étant monté sur une surface plane entre deux rondelles de montage (fournies).
Le LC901 est également disponible en configurations métriques, avec des échelles allant de 0 à 10 000 à 0 à 500 000 N. Veuillez consulter le LCM901 pour plus de détails, ou contactez notre service Pression pour plus d'informations.
Le LC901 est également disponible en configurations métriques, avec des échelles allant de 0 à 10 000 à 0 à 500 000 N. Veuillez consulter le LCM901 pour plus de détails, ou contactez notre service Pression pour plus d'informations.
PDF & Manuels
Afficher les évaluations et les avis
Rated 3 out of
5
by
Anonymous from
120 Ohm Load Cells
The load cells have 120 Ohm resistance. Many of the load cell amplifiers available, including the one recommended for this product, require the load cell to have at least 300 Ohms resistance. That makes this device hard to use.
Date published: 2020-10-26
What is the actual transducer height without the additional washers?
MLFEP, Thank you for your question. Please open the spec sheet and review the "W" dimension corresponding to your range.
Date published: 2025-09-04
What is the outside diameter of the signal cable and what is the wire gauge of its conductors?
dmeigs LC901 wire gauge is 24 AWG, for further questions kindly email pressure@omega.com
Thank you
Date published: 2020-07-03
Are the top and bottom washers required if the bottom of the transducer sits on a flat surface, and the item on the top has a .750 O.D. and .266 I.D.?
The top washer should always be used. It assures the load is distributed around the I.D. evenly. The bottom washer would not be need if the surface the surface the load is resting on is perfectly flat
Date published: 2025-09-27