1-800-663-4209 | Welcome to our new website, found an issue or bug? Please report it here
ILD44-UTP-C4EI
Large Display Meters & PID Controllers
Choose a Variant
Data Interface
Added to Your Shopping Cart
Configuration complete.
Please add to cart to keep it or exit the configuration
Please add to cart to keep it or exit the configuration
Failed to Save Configurations, Click on Configure Button Start Again
Product Specs
<< See all Product Models| Brand |
 |
| A/D Conversion | Dual slope |
| Accuracy | ± 0.5 °C |
| Accuracy Detail | ±0.5°C temperature; 0.03% rdg |
| Alarm modes | Band, High/Low, Latch/Unlatch, Normally Open/Closed, Process/Deviation |
| Common Mode Rejection | 120 dB |
| Control Mode | Reverse (heat) or direct (cool) |
| Current Measurement Range | 0 to 20 mA |
| Data Interface | Ethernet, RS485, RS422 |
| Data Interface Note | Ethernet : Standards compliance IEEE 802.3 10Base-T Supported Protocols : TCP/IP, ARP, HTTPGET RS232/RS422/RS485/MODBUS : Selectable from menu; both ASCII and MODBUS protocol selectable from menu; programmable 300 to 19.2 K baud; complete programmable setup capability; program to transmit current display, alarm status, min/max, actual measured input value and status. RS485 : Screw terminals |
| Decimal Selection | 0, 0,001, 0,01, 0,1 |
| Digital Filter | Programmable |
| Display Color | Red, Green, Amber |
| Display Size | 57.2 mm (2.25 in) |
| Display Type | 4 Digit, 7 Segment LED |
| Display Type Note | 4-digit or 6-digit, 7-segment LED 57.2 mm (2.25") or 101.6 mm (4.00") red, green and amber programmable colors for process variable, set point and temperature units |
| Electrical Connection | Screw Terminal |
| Enclosure Ratings | IP65, NEMA Type 4 |
| Excitation Voltage Note | Optional in Place of Communication |
| GrossWeightValue | 0.15 |
| Impedance Input | 10 MΩ for 100 mV, 1 MΩ for 1 or 10 Vdc |
| Input Configuration | Single-ended |
| Input Type | Themocouple, RTD, Current, Voltage |
| Isolation | Power to Input/Output: 2300 Vac per 1 min test (RS232/485, input or output) Between Inputs: 500 Vac per 1 min test |
| Normal Mode Rejection | 60 dB |
| Offset Adjustment | -1999 to +9999 |
| Operating Temperature, Max | 40 °C |
| Operating Temperature, Min | 0 °C |
| Polarity | Unipolar |
| Power Consumption | 22.5 W |
| RTD Type | 100/500/1000 Ω Pt sensor, 2-, 3- or 4-wire; α= 0.00385 or 0.00392 |
| Reading Rate | 3 samples/sec |
| Relative Humidity | 90% RH non-condensing |
| Resolution | 1°/0.1°; 10 µV process |
| Sensor/Transmitter Power | 24 Vdc @ 25 mA |
| Series ID | iLD-Series |
| Set Point Adjustment | -1999 to 9999 counts |
| Span Adjustment | 0.001 to 9999 counts, programmable |
| Step Response | 0.7 sec for 99.9% |
| Supply Power Note | 100 to 240 Vac ±10%, 50/60 Hz |
| Supply Voltage | 100 to 240 Vac |
| Temperature Stability | RTD: 0.04°C/°C;Thermcouple @ 25°C (77°F): 0.05°C/°C—cold junction |
| Thermocouple Lead Resistance, Max | 100 Ω |
| Thermocouple Type | J, K, T, E, R, S, B, C, N, L |
| Voltage Measurement Range | 0 to 100 mV, 0 to 1 V, 0 to 10 Vdc |
| Warm-Up to Rated Accuracy | 60 min |
| Country of Origin | Mexico |
| See All Specs | |
PDFs & Manuals
Show Ratings & Reviews