1-800-663-4209 | Welcome to our new website, found an issue or bug? Please report it here
EWS-TC-K
Environmental Wall Mount Sensors
Choose a Variant
Sensor Type
Added to Your Shopping Cart
Configuration complete.
Please add to cart to keep it or exit the configuration
Please add to cart to keep it or exit the configuration
Failed to Save Configurations, Click on Configure Button Start Again
Product Specs
<< See all Product Models| Brand |
 |
| Accuracy | ± 1.1 °C |
| Electrical Connection | Pigtail Leads |
| Enclosure Material | ABS |
| GrossWeightValue | 0.15 |
| Height | 45 mm |
| Lead Length | 3.3 ft |
| Lead Material | PFA |
| Length | 79 mm |
| Measurement Type | Temperature |
| Mounting | Wall Mount |
| Operating Temperature, Max | 60 °C |
| Operating Temperature, Min | 0 °C |
| Sensor Length | 1 m |
| Sensor Type | Thermocouple Type K |
| Series ID | EWS-WALL-MNT-ALL |
| Width | 54 mm |
| Wire Gauge | 24 AWG |
| Country of Origin | United States |
| See All Specs | |
PDFs & Manuals
Show Ratings & Reviews
Rated 5 out of
5
by
GregO123 from
It works great!
The documentation is a bit confusing as it is for a slightly different version than the one I bought (barometric pressure) but was easy enough to figure out. Overall the device works well and is very reliable. We have several of them. It would be nice if they came with a cal cert, but again, it is easy enough to get the device certified.
Date published: 2025-10-31
Rated 5 out of
5
by
Derek B from
As expected!
Delivered and working as expected. Installation was smooth with no issues.
Date published: 2025-01-13
Rated 5 out of
5
by
Anonymous from
Best value for space temperature monitoring
A clean, simple & cost-effective wall mount sensor
Date published: 2022-11-15
Rated 2 out of
5
by
bob1 from
Not even close
I've installed one of these so far. It read 84 F. I checked it with two accurate (expensive) and they both read 71 F. Apparently I need to calibrate it.
I hope the rest are a little closer.
Date published: 2016-03-18
Rated 1 out of
5
by
IBS Guy from
Troublesome Product
Constantly read high. Was told by customer support that the unit could handle 18 volts DC maximum despite the fact that the documentation said 24. Changed to a 15 volt supply and still had the same problem. Used a heat gun on the unit and noticed the board had a 90° hot spot on it. Maybe the RTD was picking some of that up. In the end I went with something else.
Date published: 2016-03-14