DRTB-RAIL

DIN Rails, 35x7.5 mm & 35x15 mm, Standard and Pre-Cut Lengths

5.0

(2)

Models In Stock

35x7.5 mm & 35x15 mm in 1 Meter & 2 Meter Lengths
Steel with Electrolytic Zinc Plating
Pre-Cut Lengths for Standard Sub-Panel Widths
Stand-Off Brackets: 45° Angle and Straight

See Product Overview

DRTB-RAIL

From ^$ 2.44

Models In Stock

Shop Models

More Variations Available

See all series options below

Product Overview

Amperage, Max 0 A
Color Options Black
Materials Steel with Electrolytic Zinc Plating
Voltage Rating N/A
Wire Gauge N/A

The DRTB-Rails Series DIN Rails enhances design capabilities, saves space and reduces labor. DIN rails have been accepted throughout the world, allowing the designer to mount a wide variety on control components, devices and terminal blocks, etc. on the same rail. DRTB-Rails are perforated steel with electrolytic zinc plating and available in 35x7.5mm and 35x15 mm sizes. These DIN rails comply with DIN 50045, 50022 and 50035 standards.

Pre-Cut DIN Rails
Pre-cut DIN rails are offered in widths to match enclosure sizes. An enclosure, 12H x 10” W, would use DRTB-RAIL-10. This DIN rail measures 8.75' wide, just short of the 8.88' wide sub-panel.

Support Brackets
Support brackets elevate DIN rails away from the sub-panel to facilitate component wiring access. Angled brackets tilt the DIN rails by 45° to improve visibility. Straight brackets are available in three heights for optimum positioning of the rails.

Compliance