Netherlands 07077 03815 | International +31 (0) 7077 03815 | Welcome to our new website, found an issue or bug? Please report it here
DP7600-Series
Added to Your Shopping Basket
Configuration complete.
Please add to basket to keep it or exit the configuration
Please add to basket to keep it or exit the configuration
Failed to Save Configurations, Click on Configure Button Start Again
Product Specs
<< See all Product Models| Brand |
 |
| Accuracy | ± 0.01 % |
| Accuracy Detail | ± 0.01% of reading ± 1 count of A/D @ 25°C (77°F) |
| Channels | One channel standard, second channel optional |
| Convert/Hold Input | Normally high; if pulled low, holds display |
| Cutout Dimensions | 2.45 x 5.06 in |
| Digital Filter | Programmable Cutoff Frequency |
| Display Note | -32768 to 32767 with programmable decimal points; 14 mm (0.56") red LED |
| Display Type | LED |
| Electrical Connection | Screw Terminal |
| Form factor | 1/8 DIN |
| Height | 2.7 in |
| Input Analog Filter | 4-pole active anti-alias; 500 Hz cutoff on single-channel unit and 250 Hz cutoff on dual-channel unit |
| Input Bias Current | ± 50 nA maximum ± 100 pA/°C (per input channel) |
| Input Configuration | Front Keypad |
| Internal Resolution | 16 bit |
| Length | 6.9 in |
| Measurement Type | Current, Strain, Voltage |
| Mounting | Panel |
| Number of Digits | 5 |
| Number of Inputs | 1 |
| Operating Temperature, Max | 60 °C |
| Operating Temperature, Min | -20 °C |
| Output Method | RJ11 jack for serial interface |
| Peak Detection | Updated at rate selected by digital filter, peak stored in memoryrogrammed to give limit #1 output up to 100 seconds after a programmed limit is reached. This output can be used to reset the peak reading by tying limit #1 output to remote input |
| Power Consumption | 8 W |
| Reading Rate | Limited to 1000/s divided by number of channels |
| Remote Inputs | Display Peak, Display Runout, Reading, Reset Peak, Runout Reading, Tare |
| Resolution | 16-bit A/D |
| Rollover Error | ± 2 counts of A/D @ 25°C (77°F) |
| Runout Mode | Updated at rate selected by digital filter. Runout is normally stored in memory and recalled via front-panel switch, over the serial interface, or by selecting runout display mode on rear connector. |
| Sampling Rate | 1000 Hz |
| Sensor Excitation | ± 15 Vdc, ± 5 Vdc @ ± 50 mA |
| SetPoint Outputs | 4 isolated opencollector transistor outputs rated 30 Vdc maximum; will sink up to 50 mA; 300 V isolation between limit outputs and system ground; limit #1 can be programmed to be delayed from 1 to 100 seconds |
| Settable Parameters | Digital Filter, Limits, Offset, Span |
| Weight | 370 g |
| Width | 5.18 in |
| See All Specs | |
PDFs & Manuals