1-800-663-4209 | Welcome to our new website, found an issue or bug? Please report it here
DMD-Srs-Alarm-Module
DMD Series Alarm Module - DC Input to Single Alarm
- Easy Field Setup --- One Minute Setup for 24 Input Ranges
- Switch Selectable Relay Configuration
- Removable Plugs for Faster Installation
- Input Tracker and Alarms Status LEDs
DMD-Srs-Alarm-Module
From
C$
554.69
Product Overview
- Enclosure Ratings IP40
- Height 117 mm
- Impedance Input Voltage: 250 kΩ minimum,Current: 50 Ω typical,Voltage Burden: 1 Vdc at 20 mA current input
- Input Range Note 24 field selectable ranges via switch settings_x000D_ Voltage: 0-50 mV to 0-10 Vdc_x000D_ Bipolar Voltage: ±5 Vdc or ±10 Vdc_x000D_ Current: 0-1 mADC to 0-20 mADC, 4-20 mADC
- Isolation 1200V Isolation: power to input 600 Vac or 600 Vdc common mode protection
- Length 122 mm
- Number of Outputs 2
- Operating Temperature, Max 60 °C
- Operating Temperature, Min -10 °C
- Output Detail 8 Amps @ 240 Vac resistive load 5 Amps @ 240 Vac inductive load 8 Amps @ 30 Vdc resistive load 3.5 Amps @ 30 Vdc inductive external contact protection such as a RC snubber is recommended for inductive loads
- Power Consumption 2 W
- Reset Toggles relay to opposite state when pressed; resets latching relay if latching relay mode is selected
- Response Time 70 ms
- Temperature Stability better than 1% of span over operating temperature range; better than 0.02% of span per °C
- Width 22.5 mm
- Wire Gauge 14 AWG
The DMD1080 accepts a DC voltage or current input and provides visual alarm indication and alarm relay contact outputs. 15 voltage and 9 current input ranges can be field configured via external rotary and slide switches. Offset ranges such as 1 to 5 Vdc and 4 to 20 mA are also included. Heavy-duty relay contacts allow the module to directly control high capacity loads. Front accessible potentiometers are used to adjust the alarm setpoint from 0 to 100% and the deadband from 1 to 100%. The unit provides a single setpoint adjustment of the two DPST relay contacts. The alarm output can be field configured for HI or LO operation, latching or non-latching, and normal or reverse acting.
PDFs & Manuals